HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 100

1 Commands for displaying and configuring the system message logs TABLE 3 Commands for viewing or configuring the system parameters and message logs Command Description auditCfg auditDump errClear errDelimiterSet errDump errFilterSet errModuleShow errShow pdShow portErrShow portLogClear portLogDisable portLogDump portLogDumpPort portLogEnable portLogEventShow portLoginShow portLogPdisc portLogReset portLogResize portLogShow portLogShowPort portLogTypeDisable portLogTypeEnable setVerbose snmpConfig supportFfdc supportFtp supportSave supportShow Configures the audit message log. Displays or clears the audit log. Clears all error log messages for all switch instances on this control processor (CP). Sets the error log start and end delimiter for messages pushed to the console. Displays the entire error log, without page breaks. Use the -r option to show the messages in reverse order, from newest to oldest. Sets an error severity filter for the system console. Displays all the defined error log modules. Displays the entire error log, with page breaks. Use the -r option to show the messages in reverse order, from newest to oldest. Displays the contents of the panic dump and core dump files. Displays the port error summary. Clears the port log. If the port log is disabled, this command enables it. Disables the port log facility. Displays the port log, without page breaks. Displays the port log of the specified port, without page breaks. Enables the port log facility. Displays which port log events are currently being reported. Displays port logins. Sets or clears the debug pdisc_flag. Enables the port log facility. Resizes the port log to the specified number of entries. Displays the port log, with page breaks. Displays the port log of the specified port, with page breaks. Disables an event from reporting to the port log. Port log events are described by the portLogEventShow command. Enables an event to report to the port log. Port log events are described by the portLogEventShow command. Sets the verbose level of a particular module within the Fabric OS. Manages the SNMP agent configuration. Enables and disables FFDC. Sets, clears, or displays support FTP parameters or a time interval to check the FTP server. Collects RASLog, trace files, and supportShow (active CP only) information for the local CP and then transfers the files to an FTP server. The operation can take several minutes. Executes a list of diagnostic and error display commands. This output is used by your switch service provider to diagnose and correct problems with the switch. The output from this command is very long. 14 Fabric OS Message Reference 53-1002448-01