HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 589

Chapter MFIC System Messages 70 MFIC-1001 Message , [MFIC-1001], ,, ERROR, , Failure at sysmod_scn registry rc= . Probable Cause Indicates that the system is temporarily out of resources. Recommended Action This error is often transitory. Execute the reBoot or haFailover commands (if applicable). If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. Severity ERROR MFIC-1002 Message , [MFIC-1002], ,, INFO, , Chassis FRU header not programmed for switch NID, using defaults (applies only to FICON environments). Probable Cause Indicates that the custom switch node identification data (NID) fields are not programmed in nonvolatile storage. The default values are used. The switch NID is used only in the following Single Byte (SB) Extended Link Services (ELS) frames: • Request Node Identification Data (RNID) • Registered Link Incident Record (RLIR) The use of SB-3 link incident registration and reporting is typically limited to Fibre Connectivity (FICON) environments. Recommended No action is required if SB-3 link incident registration and reporting is not used by the host or if Action default values are desired for the switch node descriptor fields. Severity INFO Fabric OS Message Reference 503 53-1002448-01