HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 409

FICU-1007 39 FICU-1007 Message , [FICU-1007], ,, WARNING, , : Failed to allocate memory while performing . Probable Cause Indicates that memory resources are low. This may be a transient problem. Recommended Action Check the memory usage in the switch using the memShow command. If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. Severity WARNING FICU-1008 Message , [FICU-1008], ,, WARNING, , FMS mode has been enabled. Ports: have been disabled due to port address conflict. Probable Cause Indicates that the specified ports were disabled when FMS mode was enabled. This is due to a port address conflict or the port address being reserved for the CUP management port. Recommended No action is required. Action Severity WARNING FICU-1009 Message , [FICU-1009], ,, WARNING, , FMS Mode enable failed due to insufficient frame filtering resources on some ports. Probable Cause Indicates that the frame filtering resources required to enable FMS mode were not available on some of the ports. Recommended Execute the perfDelFilterMonitor command to delete the filter-based performance monitors used Action on all ports to free up the resources. Severity WARNING FICU-1010 Message Probable Cause , [FICU-1010], ,, WARNING, , FMS Mode enable failed due to port(s) with areas 0xFE or 0xFF is(are) connected to device(s). Indicates that FMS mode was not enabled because ports with 0xFE or 0xFF areas are connected to the devices. Fabric OS Message Reference 323 53-1002448-01