HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 145

AUTH-1016 5 AUTH-1016 Message , [AUTH-1016], ,, ERROR, , Invalid value to start HBA authentication port: , . Probable Cause This may relate to an internal failure. Recommended Copy the message, collect switch information using the supportShow command, and contact your Action switch service provider. Severity ERROR AUTH-1017 Message , [AUTH-1017], ,, ERROR, , Invalid value to start authentication request: port , operation code . Probable Cause Indicates an internal problem with the Secure Fabric OS. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1018 Message , [AUTH-1018], ,, ERROR, , Invalid value to check protocol type: port . Probable Cause Indicates an internal problem with the Secure Fabric OS. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1020 Message Probable Cause , [AUTH-1020], ,, INFO, , Failed to create timer for authentication: port . Indicates that an authentication message's timer was not created. Fabric OS Message Reference 59 53-1002448-01