HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 277

EM-1045 25 EM-1045 Message , [EM-1045], ,, WARNING, , is being powered . Probable Cause Indicates that an automatic power adjustment is being made because of the (predicted) failure of a power supply or the insertion or removal of a port blade. The new state value can be one of the following: • On - A port blade is being powered on because the power is available (a power supply was inserted or a port blade was removed or powered down). • Off - A port blade has been powered down because of the (predicted) failure of the power supply. • Down - A newly inserted port blade was not powered on because there was not enough power available. Recommended The Brocade 24000 requires only a single power supply for a fully populated chassis; however, you Action must always operate the system with at least two power supplies for redundancy. Severity WARNING EM-1046 Message , [EM-1046], ,, WARNING, , Sysctrl reports error status for blade ID for the blade in slot Probable Cause Indicates that the specified blade is incompatible. Recommended Action If the blade ID listed is incorrect, the field-replaceable unit (FRU) header for the blade is corrupted and the blade must be replaced. If the error is due to platform, the blade ID listed is not supported for that platform (CP) type. Remove the blade from the chassis. If the error is due to backplane, the CP type (CP256) is not supported on that chassis (backplane revision D2). Remove the blade from the chassis. If the error is due to switch configuration, the blade's logical switch configuration is not correct. Execute the lscfg command to correct the switch or port configuration for the ports on the blade. Severity WARNING EM-1047 Message Probable Cause , [EM-1047], ,, INFO, , CP in slot not faulty, CP ERROR deasserted. Indicates that the control processor (CP) is no longer faulted. This message usually follows the EM-1033 message. The new standby CP is in the process of restarting and has turned off the CP_ERR signal. Fabric OS Message Reference 191 53-1002448-01