HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 840

115 ZONE-1005 Recommended No action is required. Action Severity INFO ZONE-1005 Message , [ZONE-1005], ,, INFO, , HARD and SOFT zones(, ) definitions overlap. Probable Cause Indicates that a port is zoned with mixed devices (WWN and D,I). During zoning database cross checking, either of the following is detected: • A port zone member is also listed as a member of a Mixed zone. • A WWN zone member is also specified as a member of a Mixed zone. Use hard zone enforcement whenever possible. Hard zones are more secure than session-based hard zones. Both types of zones trap a PLOGI, but hard zones filter out the I/O frames which session-based hard zones do not. Recommended If hard zone enforcement is preferred, edit the zoning database to have the port zoned with devices Action defined as WWN or D,I, but do not mix the methods used to define these zone members. Severity INFO ZONE-1006 Message , [ZONE-1006], ,, WARNING, , WWN ()in HARD PORT zone . Probable Cause Indicates that one or more devices are zoned as WWN and D,I devices. The devices are used to specify zone members over separate zones. Recommended If hardware zoning enforcement is preferred, edit the zoning database to have the device zoned Action using only one specification type: WWN or D,I. Severity WARNING ZONE-1007 Message Probable Cause , [ZONE-1007], ,, INFO, , Ioctl() in () at port () returns code () and reason string (). Indicates that frame filter logic reported a failure during the specified I/O Control (IOCTL) call. This is usually a programming error when adding CAM entries before the filter setup. 754 Fabric OS Message Reference 53-1002448-01