HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 354

37 FCR-1061 VC_RDY mode: Virtual-channel flow control mode. This is a proprietary protocol. R_RDY mode: Receiver-ready flow control mode. This is the Fibre Channel standard protocol, that uses R_RDY primitive for flow control. Severity WARNING FCR-1061 Message , [FCR-1061], ,, INFO, , Backbone fabric created on port . Probable Cause Indicates that a backbone fabric was built on the specified port. Recommended No action is required. Action Severity INFO FCR-1062 Message , [FCR-1062], ,, INFO, , Port disabled, system only supports EX/VEX_ports. Probable Cause Indicates that the maximum number of supported EX_ports or VEX_ports was exceeded. To enable the specified port, disable any other operational port then re-enable the port. Recommended No action is required. Action Severity INFO FCR-1063 Message , [FCR-1063], ,, INFO, , Fabric for switch with domain ID: mismatch with local fabric ID . Probable Cause Indicates that the fabric ID of the switch does not match the local switch. Recommended Run the switchShow command to display the fabric ID. Change the fabric ID to match on both ends Action by modifying either the local or remote host using the fcrConfigure command. Severity INFO 268 Fabric OS Message Reference 53-1002448-01