HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 843

115 ZONE-1018 Recommended Edit the zone database to make sure that only one initiator is set for each FA zone configuration. Action Severity ERROR ZONE-1018 Message , [ZONE-1018], ,, ERROR, , Incorrect zoning enforcement type() at port(). Probable Cause Indicates that an incorrect zoning enforcement type was reported on the specified port. This is a software error. A QuickLoop zone type (value = 4) or an uninitialized type (value = 0) are invalid. The following are the valid zone type values: • 1 - Hard port zone • 2 - Hard wwn zone • 3 - Session-based hard zoning • 5 - FA zone QuickLoop zones are not supported in Fabric OS version 4.x or later. Recommended If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP Action transfers; then execute the supportSave command and contact your switch service provider. Severity ERROR ZONE-1019 Message , [ZONE-1019], ,, ERROR, , Transaction Commit failed. Reason code () - \"\" Probable Cause Indicates that reliable commit service (RCS) had a transmit error. RCS is a protocol used to transmit changes to the configuration database within a fabric. Recommended Action Often this message indicates a transitory problem. Wait a few minutes and retry the command. Make sure your changes to the zone database are not overwriting the work of another administrator. Execute the cfgTransShow command to determine if there is any outstanding transaction running on the local switches. If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. Severity ERROR Fabric OS Message Reference 757 53-1002448-01