HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 687

SEC-1096 94 SEC-1096 Message , [SEC-1096], ,, ERROR, , Failed to delete because . Probable Cause Indicates a policy cannot be removed because deleting it would result in invalid security policy configuration. Recommended Verify the security policy configuration requirements and remove any policies that require the policy Action you want to remove first. Severity ERROR SEC-1097 Message , [SEC-1097], ,, ERROR, , Cannot find policy set. Probable Cause Indicates the specified policy could not be found. Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the Action supportSave command and contact your switch service provider. Severity ERROR SEC-1098 Message , [SEC-1098], ,, ERROR, , No FCS list. Probable Cause Indicates the specified policy could not be found. Recommended Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command Action and contact your switch service provider. Severity ERROR SEC-1099 Message Probable Cause , [SEC-1099], ,, ERROR, , Please enable your switch before running secModeEnable. Indicates there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Fabric OS Message Reference 601 53-1002448-01