HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 680

94 SEC-1073 SEC-1073 Message , [SEC-1073], ,, ERROR, , No FCS policy in list! Probable Cause Indicates the specific policy type is empty. The security database is corrupted for unknown reasons. Recommended Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command Action and contact your switch service provider. Severity ERROR SEC-1074 Message , [SEC-1074], ,, ERROR, , Cannot execute the command on this switch. Please check the secure mode and FCS status. Probable Cause Indicates a security command was run on a switch that is not allowed to run it either because it is in non-secure mode or because it does not have the required fabric configuration server (FCS) privilege. Recommended Action If a security operation that is not allowed in non-secure mode is attempted, do not perform the operation in non-secure mode. In secure mode, run the command from a switch that has required privilege, that is, either a backup FCS or primary FCS. Severity ERROR SEC-1075 Message , [SEC-1075], ,, ERROR, , Fail to new policy set on all switches. Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. Severity ERROR 594 Fabric OS Message Reference 53-1002448-01