HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 282

25 EM-1066 Recommended Upgrade the Fabric OS firmware or the SAS firmware using the firmwareDownload command. Refer Action to the release notes for a compatible version of firmware. Severity WARNING EM-1066 Message , [EM-1066], ,, INFO, , SAS Virtualization Services are now available . Probable Cause Indicates that the previously incompatible Fabric OS or Storage Application Services (SAS) firmware has been upgraded and is now compatible. Recommended No action is required. Action Severity INFO EM-1067 Message , [EM-1067], ,, WARNING, , Stopping synchronization of the system due to incompatibility with standby CP. Probable Cause Indicates that the software version on the standby CP is incompatible with this software feature enabled on this Fabric OS firmware version. Recommended Action Upgrade the software on the standby CP or disable the software feature on this CP. To disable the Ethernet switch service, execute the fosconfig --disable ethsw command. To view the buffer optimization mode for the slots execute the bufopmod --showall command, and then execute the bufopmode --reset slot command to disable the feature for those slots before downgrading. To disable FC8-16 serdes tuning mode, execute the serdestunemode --reset command. Severity WARNING EM-1068 Message Probable Cause , [EM-1068], , FFDC, ERROR, , High Availability Service Management subsystem failed to respond. A required component is not operating. Indicates that the High Availability (HA) subsystem has not returned a response within four minutes of the request from the environmental monitor (EM). It usually indicates that some component has not started properly or has terminated. The specific component that has failed may be indicated in other messages or debug data. There are serious internal Fabric OS configuration or hardware problems on the switch. 196 Fabric OS Message Reference 53-1002448-01