HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 358

37 FCR-1075 Recommended Keep the number of LSAN Zones to the lower limit of the two CPs or upgrade the remote CP. Action Severity ERROR FCR-1075 Message , [FCR-1075], ,, ERROR, , Zone Name configuration is larger than characters in the edge fabric connected to port . Probable Cause Indicates that the zone name configuration size created in the connected fabric exceeds the maximum supported by the FC Router. This size is equal to the total number of characters used by all the zone names in the edge fabric zoning database. The limit includes both logical storage area network (LSAN) and Non-LSAN zone names defined in zoning name database of the edge fabric. Recommended Limit the zone configuration size in the edge fabric connected to this port by either reducing Action number of zones or changing the zone names to smaller names. Severity ERROR FCR-1076 Message , [FCR-1076], ,, INFO, , Port disabled, system only supports front domains. Probable Cause Indicates that the maximum number of supported front domains was exceeded. To enable the specified port, disable any other operational front domain and then re-enable the port. Recommended Make sure to remain within the maximum of supported front domains. Action Severity INFO FCR-1077 Message Probable Cause , [FCR-1077], ,, WARNING, , Port rejected fabric binding request/check from the M-Model switch; . Indicates that an M-Model edge switch attempted to either activate or check the fabric binding. This port will be disabled if this event occurred during a check of fabric binding and not during failure to activate fabric binding. The error is caused when the binding list details configured on the M-Model switch does not match with the currently configured front port domain ID and WWN of the EX_Port on which this operation was attempted. 272 Fabric OS Message Reference 53-1002448-01