HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 272

25 EM-1016 EM-1016 Message , [EM-1016], ,, WARNING, , Cold recovery failed (). Probable Cause Indicates that a problem was discovered when performing consistency checks during a cold boot. Recommended Action Monitor the switch. If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. Severity WARNING EM-1018 Message , [EM-1018], , FFDC, CRITICAL, , CP blade in slot failed to retrieve current chassis type (//0x). Probable Cause Indicates that there was a failure to read the chassis type from the system. Recommended Verify that the control processor (CP) blade is operational and is properly seated in its slot. Action Severity CRITICAL EM-1019 Message , [EM-1019], ,, WARNING, , Current chassis configuration option () is not compatible with standby firmware version (Pre 4.4), cannot allow HA Sync. Probable Cause Indicates that the current chassis configuration option is not supported by the firmware on the standby control processor (CP). This is true even if the standby CP comes up and is operational. High availability (HA) synchronization of the CPs will not be allowed. Recommended Change the chassis configuration option to 1 using the chassisConfig command, or upgrade the Action firmware on the standby CP to the version running on the active CP. Severity WARNING EM-1020 Message Probable Cause , [EM-1020], , FFDC, ERROR, , Unit in with ID is faulted, it's an FCoE blade and the Ethernet switch service is not enabled. Please run . Indicates that a blade inserted in the specified slot requires the Ethernet switch service, which is not enabled. The blade is faulted. 186 Fabric OS Message Reference 53-1002448-01