HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 682

94 SEC-1080 Recommended Run the command again using a valid policy name. Action Severity ERROR SEC-1080 Message , [SEC-1080], ,, ERROR, , Operation denied. Please, use secModeEnable command. Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. Severity ERROR SEC-1081 Message , [SEC-1081], ,, ERROR, , Entered a name for a DCC policy ID that was not unique. Probable Cause Indicates the device connection control (DCC) policy name given in the secPolicyCreate command was the same as another DCC policy. Recommended Make sure that the DCC policy name has a unique alphanumeric string, and run the Action secPolicyCreate command again. Severity ERROR SEC-1082 Message , [SEC-1082], ,, ERROR, , Failed to create policy. Probable Cause Indicates the security policy was not created due to faulty input or low resources. Recommended Use proper syntax when creating policies. If the security database is too large, you must delete Action other members within the database before adding new members to a policy. Severity ERROR 596 Fabric OS Message Reference 53-1002448-01