HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 101

Displaying and clearing system message logs 1 TABLE 3 Commands for viewing or configuring the system parameters and message logs (Continued) Command Description syslogdFacility syslogdIpAdd syslogdIpRemove syslogdIpShow traceDump Changes the syslogd facility. Adds an IP address as a recipient of system messages. Removes an IP address as a recipient of system messages. Views the currently configured IP addresses that are recipients of system messages. Displays, initiates, or removes a Fabric OS module trace dump. Displaying and clearing system message logs This section provides information on viewing and clearing RASLog messages. These procedures are valid for all the supported platforms. Viewing RASLog messages from Web Tools To view the system message log for a switch from Web Tools, perform the following steps. 1. Launch Web Tools. 2. Select the desired switch from the Fabric Tree. The Switch View displays. 3. Click the Switch Events tab. You can view the switch events and messages in the Switch Events Report displayed. In dual-domain switches, an Event button exists for each logical switch. Only messages relating to that switch (and chassis) will be displayed. Displaying RASLog messages To display the system message log with no page breaks, perform the following steps. 1. Log in to the switch as admin. 2. Enter the errDump command at the command line. switch:admin> errdump Version: 7.0.1 2000/12/17-05:54:30, [HAM-1004], 1, CHASSIS, INFO, switch, Processor rebooted - Reset 2000/12/17-05:55:04, [ZONE-1034], 2, FID 128, INFO, switch, A new zone database file is created. 2000/12/17-05:55:04, [FCR-1069], 3, FID 128, INFO, switch, The FC Routing service is enabled. 2000/12/17-05:55:04, [FCR-1068], 4, FID 128, INFO, switch, The FC Routing service is disabled. 2000/12/17-05:55:11, [EM-1034], 5, CHASSIS, ERROR, switch, PS 2 set to faulty, rc=2000e. [...] Fabric OS Message Reference 15 53-1002448-01