HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 513

Chapter HAMK System Messages 47 HAMK-1001 Message , [HAMK-1001], , SLOT cp-slot-number | CHASSIS, FFDC, CRITICAL, , Warm recovery failed. Probable Cause Indicates that the switch failed during the warm recovery. Recommended Action This event triggers a switch restart automatically and attempts a cold recovery. Execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. Severity CRITICAL HAMK-1002 Message , [HAMK-1002], , SLOT cp-slot-number | CHASSIS, INFO, , Heartbeat down. Probable Cause Indicates that the active control processor (CP) blade determined that the standby CP blade is down. This can be a result of a user-initiated action such as firmware download, the standby CP blade being reset or removed, or an error in the standby CP blade. Recommended Action Monitor the standby CP blade for a few minutes. If this message is due to a standby CP restart, the message HAMK-1003 will display after the standby CP is restarted. If the standby CP does not connect to the active CP after 10 minutes, restart the standby CP blade by ejecting the blade and reseating it. Severity INFO HAMK-1003 Message , [HAMK-1003], , SLOT cp-slot-number | CHASSIS, INFO, , Heartbeat up. Probable Cause Indicates that the active CP blade detected the standby CP blade. This message indicates that the standby CP blade is available to take over in case a failure happens in the active CP blade. Typically, this message is displayed when the standby CP blade restarts. Recommended No action is required. Action Severity INFO Fabric OS Message Reference 427 53-1002448-01