HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 309

FABR-1051 29 Recommended Install the required license. Action Severity INFO FABR-1051 Message , [FABR-1051], ,, ERROR, , D-Port loopback test failed for slot and port . Probable Cause Indicates that the D-Port test failed for the given slot and port due to one of the following reasons: • The SFP fault detected by Electrical loopback test failure. • The cable fault detected by optical loopback test failure. • An ASIC issue detected by remote loopback test failure. Recommended Replace the faulty SFPs, cables, or blade. Action Severity ERROR FABR-1052 Message , [FABR-1052], ,, INFO, , The configured port speed (16G/10G on non FC16 blade or 1G on FC16 blade) is invalid. Persistently disabling port . Probable Cause Indicates that the configured speed (16G/10G on FC16 blade or 1G on FC16 blade) for the specified port is invalid. Recommended Execute the portcfgspeed command to change the port speed. Action Severity INFO FABR-1053 Message , [FABR-1053], ,, CRITICAL, , The switch is disabled due to an inconsistency found in the interop config parameters. Probable Cause Indicates that the config keys have interopmode parameters such as switch.interopMode and switch.mcdtFabricmode set. Recommended Execute the interopmode command to reset the parameters. Action Severity CRITICAL Fabric OS Message Reference 223 53-1002448-01