HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 791

101 SULB-1039 SULB-1039 Message , [SULB-1039], , INFO, , CP has completed relocating the internal firmware image. Probable Cause Indicates that the firmwareDownload command process has been completed normally on the CP. Recommended Run the firmwareShow command to verify the firmware versions. Action Severity INFO SULB-1040 Message , [SULB-1040], , WARNING, , An error has occurred during relocation of the internal image on the CP. Probable Cause Indicates an error has occurred during the relocation of the internal image. The error may be caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet failure. Recommended Action Run the firmwareShow command to verify the firmware versions. Run the firmwareDownload command again if the firmware is not updated. This will cause the internal image to be relocated again. If the problem persists, contact your switch service provider. Severity WARNING SULB-1041 Message , [SULB-1041], , INFO, , Firmware has been activated successfully on standby CP. Probable Cause Indicates the firmwareActivate command has completed successfully on standby CP. Recommended Action No action is required. The firmwareActivate command has completed on standby CP as expected. Run the firmwareShow command to verify the firmware versions. Severity INFO SULB-1042 Message Probable Cause , [SULB-1042], , INFO, , Firmwareactivate command has completed successfully. Indicates the firmwareActivate command has completed successfully and switch firmware has been updated. Fabric OS Message Reference 705 53-1002448-01