HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 425

Chapter FSSM System Messages 44 FSSM-1002 Message , [FSSM-1002], , SLOT cp-slot-number | CHASSIS, INFO, , HA State is in sync. Probable Cause Indicates that the High Availability (HA) state of the active Control Processor (CP) is in synchronization with the HA state of the standby CP. If the standby CP is healthy, the failover will be nondisruptive. Recommended No action is required. Action Severity INFO FSSM-1003 Message Probable Cause Recommended Action Severity , [FSSM-1003], ,, WARNING, , HA State out of sync. Indicates that the HA state of the active CP is out of synchronization with the HA state of the standby CP. If the active CP failover occurs when the HA state is out of synchronization, the failover is disruptive. If this message was logged as a result of a user-initiated action (such as running the reBoot command), no action is required. Otherwise, execute the haSyncStart command on the active CP to resynchronize the HA state. If the HA state does not synchronize, execute the haDump command to diagnose the problem. If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. WARNING FSSM-1004 Message Probable Cause , [FSSM-1004], ,, INFO, , Incompatible software version in HA synchronization. Indicates that the active CP and the standby CP in a dual CP system are running firmware that are incompatible with each other. If the active CP fails, the failover will be disruptive. Fabric OS Message Reference 339 53-1002448-01