HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 351

FCR-1048 37 FCR-1048 Message , [FCR-1048], ,, ERROR, , On EX port () setting port credits failed. Probable Cause Indicates that the specified credit type was not set. Recommended Action Setting port credits failed. Execute the portEnable command. If the problem persists try restarting the switch. If the message persists, collect switch information using the supportShow command, and contact your switch service provider. Severity ERROR FCR-1049 Message , [FCR-1049], ,, ERROR, , EX port () received an ELP command that is not supported. Probable Cause Indicates an incoming exchange link protocol (ELP) command was issued and it is not supported. Recommended Action Run the portEnable and portDisable commands to enable and disable the port. If the problem persists contact your switch service provider. Severity ERROR FCR-1053 Message , [FCR-1053], ,, WARNING, , Port was disabled, . Probable Cause Indicates that the specified port was disabled because of a mismatched configuration parameter. Recommended Use the specified disable reason to identify a possible configuration parameter mismatch between Action the EX_Port and the switch at other end of the link. Severity WARNING FCR-1054 Message Probable Cause , [FCR-1054], ,, WARNING, , Port received ILS of incorrect size (); valid ILS size is . Indicates that an internal link service (ILS) IU of invalid size was received from the switch on the other end of the link. Fabric OS Message Reference 265 53-1002448-01