HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 853

115 ZONE-1056 ZONE-1056 Message , [ZONE-1056], ,, WARNING, , Non-ETIZ-Capable Switch (dom ) in fabric w/ETIZ Configured. Probable Cause Indicates that the cfgSave, cfgEnable, or cfgDisable commands will not work on the Fabric OS switch earlier than v6.4.0 in Interop Mode 2 (IM2) fabric when Enhanced/Overlapping TI zones (ETIZs) are configured. Recommended Remove Fabric OS switch earlier than v6.4.0 from the fabric or delete the enhanced Traffic Action Isolation (TI) zones using the zone --delete name command. Severity WARNING ZONE-1057 Message , [ZONE-1057], ,, WARNING, , TI Zone has domain running pre FOS6.4.0 firmware. TI member (Domain , Index ) is not supported. Probable Cause Recommended Action Indicates that an unsupported port index(> 511) is present in the TI zone path or the routing may not be set up correctly. Remove the port index from the TI zone using the zone --remove name command. Severity WARNING ZONE-1058 Message , [ZONE-1058], ,, WARNING, , Domain present in TI zone became unreachable due to failover disabled mode. Probable Cause Indicates that the domain present in the TI zone path is unreachable. This occurs if the TI zone paths are unavailable or the TI zone is set up incorrectly. Recommended Verify that the paths defined by TI zones are online or remove the domain from the TI zone using Action the zone --delete name command. Severity WARNING Fabric OS Message Reference 767 53-1002448-01