HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 128

2 AG-1025 Recommended Execute the ag --mapShow command to display the updated F_Port-to-N_Port mapping. Action Severity INFO AG-1025 Message , [AG-1025], ,, ERROR, , Port group of Slave N_Port is different than its Master N_Port . Probable Cause Indicates that the port groups of the Master and Slave N_Ports are different while the Trunk Area assigned to the attached F_Ports on the edge switch is the same. Recommended Action Execute the porttrunkarea --show command on the attached switch to display that the Trunk Area is assigned to all ports in the system and execute the porttrunkarea --enable command to reconfigure the Trunk Area. Severity ERROR AG-1026 Message Probable Cause Recommended Action Severity , [AG-1026], ,, WARNING, , Unable to handle the login request on port due to insufficient resources. Indicates that there are insufficient resources. Execute the configure command on the Access Gateway switch and increase the number of allowed logins on this port. If the message persists, execute the supportFtp (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. WARNING AG-1027 Message , [AG-1027], ,, WARNING, , Unable to handle this login request on port because NPIV capability is not enabled on this port. Probable Cause Indicates that N_Port ID virtualization (NPIV) is not enabled. Recommended Execute the portcfgnpivport command on the Access Gateway switch and enable the NPIV Action capability on this port. Severity WARNING 42 Fabric OS Message Reference 53-1002448-01