HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 169

BL-1039 7 Recommended Restart the switch. If the message persists, replace the switch. Action Severity CRITICAL BL-1039 Message , [BL-1039], ,, CRITICAL, , Inconsistent FPGA image version detected, faulting the blade in slot . Probable Cause Indicates that the FPGA image version is incompatible with the software version. Recommended Power cycle the blade. If the message persists, replace the blade. Action Severity CRITICAL BL-1041 Message , [BL-1041], ,, CRITICAL, , Dynamic area mode is enabled on default switch, Faulting the blade w/ ID in slot as it does not support this mode. Probable Cause Indicates that the blade does not support dynamic area mode on default switch. Recommended Turn off the dynamic area mode through Configure CLI. Action Severity CRITICAL BL-1045 Message , [BL-1045], ,, ERROR, , mini SFP+ (SN: ) is only supported in certain high port count blades, not blade in slot w/ ID . Probable Cause Indicates that the mini (form factor) SFP+ is supported only by a certain type of blade (FC8-64), but it can be inserted in other blades. Recommended Replace the mini SFP+ with an SFP or SFP+. Action Severity ERROR Fabric OS Message Reference 83 53-1002448-01