HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 488

45 FW-1435 FW-1435 Message , [FW-1435], ,, WARNING, , Switch status change contributing factor Flash: usage out of range. Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the flash usage is out of range. The policy was set using the switchStatusPolicySet command. Recommended Execute the supportSave command to clear out the kernel flash. Action Severity WARNING FW-1436 Message , [FW-1436], ,, WARNING, , Switch status change contributing factor Marginal ports: marginal out of ports:config( percent,). (Port(s) ). Probable Cause Indicates that the switch is not in a healthy state. This occurred because the number of marginal ports are greater than or equal to the policy set using the switchStatusPolicySet command. A port is faulty when the port value for Link Loss, Synchronization Loss, Signal Loss, Invalid word, Protocol error, CRC error, Port state change, or Buffer Limited Port is above the high boundary. Recommended Replace the faulty or deteriorating small form-factor pluggable (SFP). Execute the fwportdetailshow Action command to know the reason for marginal ports. Severity WARNING FW-1437 Message , [FW-1437], ,, WARNING, , Switch status change contributing factor Faulty ports: faulty out of ports:config( percent,). (Port(s) ). Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of faulty ports is greater than or equal to the policy set by the switchStatusPolicySet command. A port is considered faulty due to hardware failure such as a faulty small form-factor pluggable (SFP) or port. Recommended Replace any faulty or deteriorating SFPs. Action Severity WARNING 402 Fabric OS Message Reference 53-1002448-01