HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 205

CDR-1016 15 Recommended Whenever this error is observed persistently, power cycle the specified blade. If the problem Action persists, replace the blade. Severity WARNING CDR-1016 Message , [CDR-1016], ,, ERROR, , Port is faulted due to port re-initialization failure on internal Port S,P() with reason . Probable Cause Indicates that port is faulted due to port re-initialization failure. Recommended Whenever this error is observed persistently, power cycle the specified blade. If the problem Action persists, replace the blade. Severity ERROR CDR-1017 Message , [CDR-1017], ,, ERROR, , Blade in Slot faulted due to unavailable ports in internal Trunk. Probable Cause Indicates that blade is faulted due to unavailable ports in internal trunk. Recommended Whenever this error is observed persistently, power cycle the specified blade. If the problem Action persists, replace the blade. Severity ERROR CDR-1018 Message , [CDR-1018], ,, ERROR, , Blade in Slot faulted due to Link reset threshold value exceeded. Probable Cause Indicates that blade is faulted due to Link reset threshold exceeded. Recommended Whenever this error is observed persistently, power cycle the specified blade. If the problem Action persists, replace the blade. Severity ERROR CDR-1019 Message Probable Cause , [CDR-1019], ,, WARNING, , S,C: HW ASIC Chip TXQ FID parity error threshold reached type = 0x. Indicates an internal error in the ASIC hardware that may degrade data traffic. Fabric OS Message Reference 119 53-1002448-01