HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 274

25 EM-1033 Recommended Action Close the ejector switch (raise the slider in most blades, or completely screw in the upper thumbscrew for the FC4-48 port blade) if the field-replaceable unit (FRU) is intended for use. Refer to the appropriate Hardware Refernce Manual for instructions on inserting the switch blades. Severity ERROR EM-1033 Message , [EM-1033], ,, ERROR, , CP in set to faulty because CP ERROR asserted. Probable Cause Indicates that the standby control processor (CP) has been detected as faulty. The High Availability (HA) feature will not be available. This message occurs every time the other CP reboots, even as part of a clean warm failover. In most situations, this message is followed by the EM-1047 message, and no action is required for the CP; however, find the reason for failover. Recommended Action If the standby CP was restarted, wait for the error to clear (execute the slotShow command to determine if it has cleared). Watch for the EM-1047 message to verify that this error has cleared. If the standby CP continues to be faulty or if it was not intentionally restarted, check the error logs on the other CP (using the errDump command) to determine the cause of the error state. Reseat the field-replaceable unit (FRU). If the problem persists, replace the FRU. Severity ERROR EM-1034 Message , [EM-1034], ,, ERROR, , set to faulty, rc=. Probable Cause Indicates that the specified field-replaceable unit (FRU) has been marked as faulty for the specified reason. Recommended Action Reseat the FRU. Execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the problem persists, replace the FRU. Severity ERROR 188 Fabric OS Message Reference 53-1002448-01