HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 275

EM-1035 25 EM-1035 Message , [EM-1035], ,, ERROR, , 2 circuit paired Power Supplies are faulty, please check the AC main switch/circuit to see if it has power. Probable Cause Indicates that both power supplies associated with one of the two main circuits are present but faulty, may be the circuit's switch has been turned off, or the AC power source has been interrupted for that circuit. The Switch side value designates the circuit switch, facing the cable side of the chassis, and is one of the following: • left - Controls the odd numbered power supply units. • right - Controls the even numbered power supply units. Recommended Verify that the identified AC circuit switch is turned on, the power cord is properly attached and Action undamaged, and the power source is operating properly. Severity ERROR EM-1036 Message , [EM-1036], ,, WARNING, , is not accessible. Probable Cause Indicates that the specified field-replaceable unit (FRU) is not present on the switch. If the FRU is a World Wide Name (WWN) card, the default WWN and IP addresses are used for the switch. Recommended Action Reseat the FRU. If the problem persists, restart or power cycle the switch. Execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the problem still persists, replace the FRU. Severity WARNING EM-1037 Message Probable Cause , [EM-1037], ,, INFO, , is no longer faulted. Indicates that the specified power supply is no longer marked faulty; probably because its AC power supply has been turned on. Fabric OS Message Reference 189 53-1002448-01