HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 352

37 FCR-1055 Recommended Action Check the error message log on the other switch using the errShow command for additional messages. Check for a faulty cable or deteriorated small form-factor pluggable (SFP). Replace the cable or SFP if necessary. Run the portLogDumpPort command on both the receiving and transmitting port. Run the fabStateShow command on the transmitting switch. If the message persists, collect switch information using the supportShow command, and contact your switch service provider. Severity WARNING FCR-1055 Message , [FCR-1055], ,, INFO, , Switch with domain ID does not support backbone to edge imports. Probable Cause Indicates that a switch that does not support backbone-to-edge routing was detected in the backbone. Edge-to-edge routing will work, but backbone-to-edge routing might fail. Recommended No action is required if backbone to edge routing is not required. Otherwise replace the switch with Action one that supports backbone to edge routing. Severity INFO FCR-1056 Message , [FCR-1056], ,, INFO, , Switch with front domain ID does not support backbone to edge imports. Probable Cause Indicates that a switch that does not support backbone-to-edge routing is running in the MetaSAN. Recommended No action is required if backbone-to-edge routing is not needed. Otherwise replace the switch with Action one that supports backbone to edge routing. Severity INFO FCR-1057 Message , [FCR-1057], ,, ERROR, , EX_Port() incompatible long distance parameters on link. Probable Cause Indicates that the port, which is configured in long distance mode, has incompatible long distance parameters. Recommended Check the port configuration on both sides of the link using the portCfgShow command. Action 266 Fabric OS Message Reference 53-1002448-01