HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 97

Changing the severity level of swEventTrap 1 Trap Recipient's IP address : [0.0.0.0] Trap Recipient's IP address : [0.0.0.0] Committing configuration.....done. NOTE To receive the SNMP informs, the username, the authentication protocol, the privacy protocol, and the engine ID must match between the switch and the management station. 3. Execute the snmpConfig --show snmpv3 command to verify the SNMP agent configuration. switch:admin> snmpconfig --show snmpv3 SNMP Informs = 1 (ON) SNMPv3 USM configuration: User 1 (rw): snmpadmin1 Auth Protocol: noAuth Priv Protocol: noPriv Engine ID: 80:00:05:23:01:0a:23:34:21 User 2 (rw): snmpadmin2 Auth Protocol: MD5 Priv Protocol: DES Engine ID: 80:00:05:23:01:0a:23:34:1b User 3 (rw): snmpadmin3 Auth Protocol: noAuth Priv Protocol: noPriv Engine ID: 00:00:00:00:00:00:00:00:00 User 4 (ro): snmpuser1 Auth Protocol: noAuth Priv Protocol: noPriv Engine ID: 00:00:00:00:00:00:00:00:00 User 5 (ro): snmpuser2 Auth Protocol: noAuth Priv Protocol: noPriv Engine ID: 00:00:00:00:00:00:00:00:00 User 6 (ro): snmpuser3 Auth Protocol: noAuth Priv Protocol: noPriv Engine ID: 00:00:00:00:00:00:00:00:00 SNMPv3 Trap configuration: Trap Entry 1: 10.35.52.33 Trap Port: 162 Trap User: snmpadmin1 Trap recipient Severity level: 4 Trap Entry 2: 10.35.52.27 Trap Port: 162 Trap User: snmpadmin2 Trap recipient Severity level: 4 Trap Entry 3: No trap recipient configured yet Trap Entry 4: No trap recipient configured yet Trap Entry 5: No trap recipient configured yet Changing the severity level of swEventTrap When an event occurs and if the event severity level is at or below the set severity level, the SNMP trap, swEventTrap, is sent to the configured trap recipients. By default, the severity level is set at 0 (None), implying that all the event traps are sent. Use the snmpConfig --set mibCapability command to modify the severity level of swEventTrap. Fabric OS Message Reference 11 53-1002448-01