HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 421

Chapter FSS System Messages 43 FSS-1001 Message , [FSS-1001], ,, WARNING, , Component () dropping HA data update (). Probable Cause Indicates that an application has dropped a High Availability (HA) data update. Recommended Action For dual Control Processor (CP) system, enable the HA state synchronization using the haSyncStart command. For nonbladed systems, restart the switch using the reBoot command. If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. Severity WARNING FSS-1002 Message , [FSS-1002], ,, WARNING, , Component () sending too many concurrent HA data update transactions (). Probable Cause Indicates that an application has sent too many concurrent HA data updates. Recommended Action For dual Control Processor (CP) system, enable the HA state synchronization using the haSyncStart command. For nonbladed systems, restart the switch using the reBoot command. If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. Severity WARNING FSS-1003 Message , [FSS-1003], ,, WARNING, , Component () misused the update transaction () without marking the transaction beginning. Probable Cause Indicates that the Fabric OS state synchronization (FSS) service has dropped the update because an application did not set the transaction flag correctly. Recommended For dual Control Processor (CP) system, enable the HA state synchronization using the haSyncStart Action command. For nonbladed systems, restart the switch using the reBoot command. Fabric OS Message Reference 335 53-1002448-01