HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 271

EM-1013 25 Recommended Action Reseat the specified field-replaceable unit (FRU). If the problem persists, restart or power cycle the switch. Execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the problem still persists, replace the FRU. Severity CRITICAL EM-1013 Message , [EM-1013], ,, ERROR, , Failed to update FRU information for . Probable Cause Indicates that the environmental monitor (EM) was unable to update the time alive or the original equipment manufacturer (OEM) data in the memory of a field-replaceable unit (FRU). Recommended Action If you had executed the fruInfoSet command, execute the command again; otherwise, the update is automatically attempted again. If it continues to fail, reseat the FRU. If the problem persists, replace the FRU. Severity ERROR EM-1014 Message , [EM-1014], ,, ERROR, , Unable to read sensor on (). Probable Cause Indicates that the environmental monitor (EM) was unable to access the sensors on the specified field-replaceable unit (FRU). Recommended Reseat the FRU. If the problem persists, replace the FRU. Action Severity ERROR EM-1015 Message , [EM-1015], ,, WARNING, , Warm recovery failed (). Probable Cause Indicates that a problem was discovered when performing consistency checks during a warm boot. Recommended Monitor the switch. If the problem persists, restart or power cycle the switch. Action Severity WARNING Fabric OS Message Reference 185 53-1002448-01