HP Brocade 8/12c Brocade Fabric OS Message Reference - Supporting Fabric OS v7 - Page 149

AUTH-1030 5 AUTH-1030 Message , [AUTH-1030], ,, ERROR, , Invalid message code for message: port . Probable Cause Indicates the receiving payload does not have valid message code for a particular authentication phase. Recommended Action Usually this problem is transient. The authentication might fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1031 Message , [AUTH-1031], ,, ERROR, , Failed to retrieve secret value: port . Probable Cause Indicates that the secret value was not set properly for the authenticated entity. Recommended Action Reset the secret value by using the secAuthSecret command. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. Severity ERROR AUTH-1032 Message , [AUTH-1032], ,, ERROR, , Failed to generate for payload: length , error code , port . Probable Cause Indicates that the authentication process failed to generate specific data (that is, challenge, nonce, or response data) for an authentication payload. This usually relates to internal failure. A nonce is a single-use, usually random value used in authentication protocols to prevent replay attacks. Recommended Action Usually this problem is transient. The authentication might fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR Fabric OS Message Reference 63 53-1002448-01