Pioneer AVIC-5100NEX Owner's Manual - Page 12

Chapter 01 Introduction "External storage device (USB, SD)" The SD memory card, SDHC memory card and USB memory device are collectively referred to as the "external storage device (USB, SD)". If it indicates the USB memory only, it is referred to as the "USB storage device". "SD memory card" The SD memory card and SDHC memory card are collectively referred to as the "SD memory card". "iPod" In this manual, iPod and iPhone will be referred to as "iPod". The microprocessor must be reset under the following conditions: ! Prior to using this product for the first time after installation. ! If this product fails to operate properly. ! If there appears to be problems with the op- eration of the system. ! If your vehicle position is shown on the map with a significant positioning error. 1 Turn the ignition switch OFF. 2 Press the RESET button with a pen tip or other pointed implement. Settings and recorded contents are reset to the factory settings. 8100NEX 7100NEX Notes on internal memory Before removing the vehicle battery If the battery is disconnected or discharged, the memory will be erased and must be repro- grammed. p Some of the settings and recorded con- 1 tents will not be reset. 6100NEX 5100NEX Data subject to erasure 1 The information is erased by disconnecting the yellow lead from the battery (or removing the battery itself). p Some of the settings and recorded con- tents will not be reset. Resetting the microprocessor CAUTION Pressing the RESET button resets settings and recorded contents to the factory settings. p Do not perform this operation when a device is connected to this product. p Some of the settings and recorded contents will not be reset. 1 RESET button 12 En