HP Designjet L28500 HP Designjet L28500 Printer Series - User's guide - Page 18
Restart the printer
View all HP Designjet L28500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
To turn it back on later, use the power switch at the rear. If the printer does not start automatically, press the Power button on the front panel. When the printer is turned on, it takes about 5 minutes to initialize itself. Restart the printer In some circumstances you may be advised to restart the printer. To do so, press the Power button on the front panel to turn the printer off. Wait a few moments, then press the Power button again. This should restart the printer. If the printer fails to restart, try the following alternative procedure. 1. Turn off the printer by using the power switch at the rear of the printer. Check that the residual current circuit breakers are in the up position. 2. Wait for 10 seconds. 3. Turn on the printer by using the power switch. 4. Make sure that the Power light on the front panel illuminates. If it does not, use the Power button to turn on the printer. 12 Chapter 1 Introduction ENWW