Sharp MX-2600N MX-2600N MX-3100N Operation Manual - Page 84

BEFORE USING THE MACHINE FINISHER The finisher is equipped with the offset function, which offsets each set of output from the previous set. In addition, each set of sorted output can be stapled. An optional hole punching unit can also be installed to punch holes in output. PART NAMES The following parts can be accessed when the finisher is open. (1) (2) (3) (4) (5) (6) (1) Output tray Stapled and offset output is delivered to this tray. The tray is slidable. Extend the tray for large output (12" x 18", 11" x 17", 8-1/2" x 14", 8-1/2" x 13", 8-1/2" x 13-1/2", 8-1/2" x 13-2/5", 8-1/2" x 11"R, 7-1/4" x 10-1/2"R, A3W, A3, A4R, B4, B5R, 8K and 16KR sizes). (2) Lever Use this to move the finisher in order to remove a paper misfeed, replace staples, or remove a staple jam. (3) Punch waste box (when a punch module is installed) This holds punch waste. (4) Front cover Open this cover to remove a paper misfeed, replace staples, remove a staple jam, or remove the punch scrap case. (5) Staple case This holds the staple cartridge. Pull the case out to replace the staple cartridge or remove a staple jam. (6) Staple case release lever Use this to remove the staple case. • A finisher and a saddle stitch finisher cannot be installed simultaneously. • Use caution when you turn on the power and when printing is taking place, as the tray may move up and down. SUPPLIES The finisher requires the following staple cartridge: Staple cartridge (approx. 5000 staples per cartridge x 3 cartridges) MX-SCX1 1-43 Contents