Canon MultiPASS C3500 User guide for the MPC3000. - Page 208

LCD Messages The following messages are displayed in the LCD when the MultiPASS C3000 is performing a function or encounters an error. The Error Code appears on the Activity Report. Information Messages Message AUTO REDIAL COMMUNICATING PLEASE WAIT DIALING DOCUMENT READY ECM RX ECM TX HANG UP PHONE Error Code — — — — — — — Cause The MultiPASS is waiting to redial the other party’s number because the line was busy or the other party did not answer when you tried to send the document. You tried to send a fax using Manual mode when the MultiPASS was already sending a fax from memory. The MultiPASS is dialing the receiving fax machine. The document in the Automatic Document Feeder is ready for faxing, copying, or scanning. The MultiPASS is receiving a fax using ECM. The MultiPASS is sending a fax using ECM. The telephone is off hook. Action Wait for the MultiPASS to try redialing. If that doesn’t work, wait until the MultiPASS starts to dial the number, then press STOP to cancel redialing. Try to send the document again at a later time. Wait until the fax is sent, or use memory sending. Press STOP if you want to cancel the transmission. Send the fax, make a copy, or scan the document. ECM transmissions may take longer than normal transmissions. Turn off ECM if you need to receive quickly, or if you know your local lines are in good condition. ECM transmissions may take longer than normal transmissions. Turn off ECM if you need to transmit quickly, or if you know your local lines are in good condition. Place the telephone properly into its cradle. 10-6 Troubleshooting Chapter 10