Icom IC-R9500 Instruction Manual - Page 108
Programmed scan
View all Icom IC-R9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
8 SCANS ■ Programmed scan D Setting Keypad [F-2•PROG] [EXIT/SET] Main dial Programmed scan searches for signals within a specified frequency range, using the selected tuning step increments. The result is like 'automatically' rotating of the main dial. q Push [EXIT/SET] several times to close a multifunction screen, if necessary. w Push [F-5•SCAN] to select scan setting screen. e Push [F-2•PROG] once to enter the programmed scan selection mode. rRotate the main dial to select the desired scan edges. • A pair of P0A and P0B to P9A and P9B are available. t Push [F-2•PROG] to enter the start edge frequency programming, then edit the desired frequency using the keypad. y Push [F-2•PROG] to enter the end edge frequency programming, then edit the desired frequency using the keypad. u Push [F-2•PROG] to enter the operating mode selection, then rotate main dial to select the desired operating mode. i Push [F-2•PROG] to enter the filter selection, then rotate main dial to select the desired filter. o Push [F-2•PROG] to enter the tuning steps selection, then rotate main dial or edit using the keypad to select the desired tuning steps. !0 Push [F-2•PROG] to set the programmed scan. 8-6