Icom IC-R9500 Instruction Manual - Page 66

4 RECEIVE MODES ■ TV channel operation (except for USA versions) A TV tuner is built-in to the IC-R9500, and connects to the [VIDEO IN] and [VIDEO OUT] on the rear panel using a TV jumper cable to monitor the TV programs (except for USA version). If you would rather use your TV tuner, connect the external tuner to [VIDEO IN] on the rear panel. [DISPLAY] [WFM] q Push [DISPLAY] once or twice to turn ON the desired video screen. • Push once to turn ON the mini video screen, push again to turn ON the full video screen and push again to close the video screen. w Set the desired frequency and select WFM mode. • If you connect the external tuner, this setting is not necessary. e Push [DISPLAY] to close the video screen. The video display settings can be adjusted in display set (Video) mode. (p. 11-24) D Convenient functions for TV operation • Preamp (p. 5-9) ➥ Push [P.AMP] several times to set the preamp OFF, preamp 1 ON or preamp 2 ON. Only ON/OFF is available above 30 MHz. • "P.AMP1" or "P.AMP2" appears when the preamp 1 or preamp 2 is ON below 30 MHz. "P.AMP ON" appears above 30 MHz. • Attenuator (p. 5-9) ➥ Push [ATT] several times to set the attenuator in 6 dB steps for HF bands, or 10 dB step for 30-1150 MHz. Only 20 dB is available for 1150-3335 MHz. • "ATT" and attenuation level appear when the attenu- ator is ON. • Auto notch filter (p. 5-16) ➥ Push [ANF] switch to turn the auto notch function ON or OFF. • Notch indicator (above [ANF] switch) lights when either the auto notch is ON. • VSC (voice squelch control) (p. 8-3) ➥ Push [VSC] to turn the VSC function ON or OFF. • The VSC indicator appears when the voice squelch function is set to ON. • AFC (Auto Frequency Control) (p. 5-17) ➥ Push [AFC] to turn the AFC function ON or OFF. • The AFC indicator appears when the AFC function is set to ON. 4-20