Icom IC-R9500 Instruction Manual - Page 135

SET MODE 11 ■ ACC set mode SPEECH OUT Level Sets the speech audio output level from [SPEECH OUT] from 0 to 100% in 1% steps. • Outputs approx. 200 mV at 50% (default) setting. 50% S/PDIF Output Level Sets the desired output level of [S/P DIF OUT], from 0 to 100% in 1% steps. (default: 100%) 100% REC Remote (External) Turns the control signal of external equipment output capability ON and OFF. (default: OFF) OFF • OFF • ON : No signal output from [REC REMOTE] jacks. (default) : The [REC REMOTE] jacks shorts to ground when receiving a signal or the squelch is open. External Meter Output Selects the squelch condition output for an external meter indication from pin 8 of [ACC]. Signal • Signal : Outputs the receiving signal strength level during receiving. (default) • Signal+SQL: Outputs the receiving signal strength level during receiving and outputs squelch open/close condition. External Meter Level Sets the output level for an external meter indication from 0 to 100% range in 1% steps. 50% • Approx. 2.5 V at 50% (default) setting for full-scale indication. (4.7 kΩ impedance) ERxetferneanlceMeINte/Or ULTevel Selects the receiver's reference signal condition from IN, OFF and OUT. OFF 50% • IN : Use an external reference signal for the ICR9500. • OFF : No input or output of the reference signal. (default) • OUT : Outputs the IC-R9500 reference signal to externally connected equipment(s) for their reference. NOTE: If the applied reference signal is off-frequency, or no signal is applied with "IN" selection, the IC-R9500 will not work properly. Select "OFF" or "OUT" then reboot the IC-R9500. REF Adjust Adjusts the internal reference frequency within 0 to 100% in 1% steps during frequency calibration. 40% NOTE: Default setting is different for each receiver. 11-7