Icom IC-R9500 Instruction Manual - Page 112
Auto memory write scan operation
View all Icom IC-R9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
8 SCANS ■ Auto memory write scan operation Auto memory write scan operates in the same way as programmed scan. However, when a signal is received, the received frequency is automatically written into a memory channel in the auto write bank (A00-A99). [SQUELCH] [EXIT/SET] [AUTO] Scan indicator and Auto memory write scan number appear q Push [EXIT/SET] several times to close a multifunction screen, if necessary. w Select the desired VFO or memory channel. e Select the desired operating mode. • The operating mode can also be changed while scanning. r Set [SQUELCH] control open or closed. • See page 8-3 for squelch condition. t Push [AUTO] to start the auto memory write scan. • Selected programmed scan start. • Scan screen appears. • " AUTO MEMORY WRITE SCAN " and decimal points blink while scanning. • Push numeral key (0-9) to change to the other edges. y When the scan detects a signal, the scan stops, pauses or ignores it depending on the resume setting and the squelch condition. • The received frequency is automatically written into a blank memory channel in the auto write bank. u To cancel the scan, push [AUTO]. • Pushing [F5•STOP] also cancels the scan. • Pushing [EXIT/SET] closes the scan screen. i Push and hold [F-6•RECALL] for 1 sec. to recall the frequency that was set before starting the scan, if desired. ✔ For your convenience Ten auto memory write scans can be selected directly from the keypad. Then the scan starts immediately. ➥ Push numeral key (0-9) then push [AUTO] to start the desired programmed scan. The memory clear setting of the auto write bank can be selected from the starting auto memory write scan, by pushing and holding [AUTO], or manually. See scan set mode (p. 8-4) for Auto MW SCAN Memory Clear details. 8-10