Icom IC-R9500 Instruction Manual - Page 152

11 SET MODE ■ Display set (Video) mode [F-1•Y] [F-2•Z] [F-4•DEF] [DISPLAY] [EXIT/SET] Main dial This set mode is used to set the HSB (Hue, Saturation, Brightness) color setting for video input or output, etc. NOTE: "Display set mode" is described on page 11-8. q Push [DISPLAY] momentarily to turn the mini video screen, if necessary. w Push and hold [DISPLAY] for 1 sec. to select the display set (Video) mode. e Push [F-1•Y] or [F-2•Z] to select the desired set item. r Set the desired condition using the main dial. • Push and hold [F-4•DEF] for 1 sec. to select a default condition or value. t Push [EXIT/SET] to exit from set mode. NOTE: Video output from [DATA IN] is available an NTSC system only. TV Standard Selects the TV system of your local area from "NTSC M," "PAL B/G," "PAL I," "PAL D" and "SECAM K." NTSC M NOTE: • This setting is not available for USA versions. • Default setting is different depending on versions. VIDEO IN Contrast Adjusts the LCD contrast of the video signal from [VIDEO IN] jack. Adjustable range is 0 (low contrast) to 100% (high contrast) in 1% steps. (default: 50%) 53% VIDEO IN Bright Adjusts the LCD brightness of the video signal from [VIDEO IN] jack. Adjustable range is 0 (dark) to 100% (bright) in 1% steps. (default: 50%) 50% VIDEO IN Saturation Adjusts the saturation (vibrancy of the color) of the video signal from [VIDEO IN] jack. Adjustable range is 0 (shade of gray) to 100% (vivid color) in 1% steps. (default: 50%) 50% VIDEO IN Hue (NTSC) Adjusts the hue (color type) of the video signal from [VIDEO IN] jack. Adjustable range is 0 (red) to 100 (green) in 1 steps. (default: 50) 50% NOTE: This setting is available when NTSC system signal is input from [VIDEO IN] connector. 11-24