Icom IC-R9500 Instruction Manual - Page 94

7 MEMORY OPERATION ■ Memory channels The receiver has 1220 memory channels. Memory mode is very useful for quickly changing to often-used frequencies. All 1220 memory channels are tuneable which means the programmed frequency can be tuned temporarily with the main dial, etc. in memory mode.memory channel. MEMORY CHANNEL MEMORY CHANNEL NUMBER CAPABILITY TRANSFER OVERTO VFO WRITING CLEAR Regular memory 0-999 channels (0-999) For normal use. Frequency, mode, tuning step, name, P.AMP/ATT information and etc. can be programmed. YES YES YES Auto write mem- A00-A99 Frequencies detected during auto memory ory channels (1000-1099) write scan are memorized into this bank in sequence. Mode and tuning step are written at the same time. Note that when "Auto MW Scan Memory Clear" in scan set mode is set as "ON" and auto write scan is started, all memories in this bank are cleared. YES YES YES Skip memory channels S00-S99 Undesired signals such as from beacons, con(1100-1199) trol-coded signals, etc., can be programmed to be skipped during programmed scan and auto memory write scan. When [MW] is pushed and held for 1 sec. while scan is paused, the displayed frequency is programmed into this bank regardless of the selected bank. YES YES YES Scan edge mem- P0A-P9B Memorize scan edge frequencies. 10 pairs of ory channels (1200-1219) scan edges (P0A to P9B) are programmable (upper and lower scan edges). Mode and tuning step are automatically equalized to the last programmed channel in a pair. YES YES YES 7-2