Icom IC-R9500 Instruction Manual - Page 189

15 UPDATING THE FIRMWARE IC-R9500 Firm Utility iR9500 COMMUNICATIONS RECEIVER Firmware File Name IC-R9500 IP Address Connecting to the IC-R9500. Connected to the IC-R9500. Transfer in progress... Transfer successful. Start update. Please wait a while. Version 1.00 (C) 2006 Icom Inc. Firmware up dating for the main CPU is completed. Turn the IC-R9500 power OFF, then ON again with [POWER] switch. After turning the power ON, the IC-R9500 will work with the updated firmware. The sub CPU and/or DSP firmware update will start automatically depending on the updated contents, and this will take approx. 2 minutes. DO NOT turn the IC-R9500 power OFF until the normal operational screen appears. o The screen at left is displayed. • The following dialog appears in the IC-R9500 display. RWARNING!: NEVER turn the IC-R9500 power OFF at this stage. The receiver firmware will be corrupted. !0 Click [OK] to finish the firmware update. • The "FIRMWARE UPDATING" dialog as above disappears. !1 Push [POWER] to turn the IC-R9500 power OFF, then ON again. Click [OK] to finish the firmware update. Please wait for 20sec. WARNING! NEVER turn power OFF. RX-DSP UPDATING... Please wait for 45sec. WARNING! NEVER turn power OFF. !2 Depending on the status of the update process, either of dialogs at left will appear in sequence. RWARNING!: NEVER turn the IC-R9500 power OFF at this stage. The receiver firmware will be corrupted. !3 After the dialog disappears, the firmware update is completed and the normal operation screen appears. 15-9