Icom IC-R9500 Instruction Manual - Page 55
DAPF Audio Peak Filter operation DAbout CW reverse mode DAbout CW pitch control
View all Icom IC-R9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
4 RECEIVE MODES D APF (Audio Peak Filter) operation [APF/TPF] The APF changes the audio frequency response by boosting a particular frequency to enhance a desired CW signal. The audio filter shape is also selectable from "SOFT" and "SHARP" in the others set mode. (p. 11-13) q During CW mode, push [APF/TPF] to turn the audio peak filter ON and OFF. • " APF " appears in the display and [APF/TPF] indicator above this switch lights green. w Push and hold [APF/TPF] for 1 sec. several times to select the desired audio filter width. • 320, 160 and 80 Hz filters are available. D About CW reverse mode Push BFO Interference Desired signal CW mode (LSB side) BFO Interference Desired signal CW-R mode (USB side) CW-R (CW Reverse) mode uses the opposite side band to receive CW signals. Use when interfering signals are near a desired signal and you want to use CW-R to reduce the interference. ➥ During CW mode, push and hold [SSB/CW] for 1 sec. to select CW and CW-R mode. D About CW pitch control [PITCH] [F-4•DEF] Main dial The received CW audio pitch can be adjusted to suit your preference (from 300 to 900 Hz in 5 Hz steps). This does not change the operating frequency. q During CW mode, push [PITCH] to turn the CW pitch setting screen ON and OFF. w Rotate the main dial to suit your preference. • Adjustable within 300 to 900 Hz in 5 Hz steps. • Push and hold [F-4•DEF] for 1 sec. to return to the default setting. CW Pitch Sets the desired CW pitch within 300 to 900 Hz in 5 Hz steps. (default: 800 Hz) 800 4-9