Icom IC-R9500 Instruction Manual - Page 41

3 BASIC OPERATIONS D Tuning with the main dial [VFO] Number key TUNING STEP [DOWNZ]/[YUP] Main dial Rotate the main dial to change the frequency. • The frequency changes in increments determined by the selected tuning step (see below). q Push the desired VFO number (0 to 9) and [VFO]. • 10 different sets of VFO data can be selected. w Select the desired operating mode. (p.3-7) • 10 different sets of VFO data can be selected. e Push [▲UP] or [▼DOWN] to select the desired tuning step. • Selectable tuning steps can be changed for each operating mode as shown below. r Rotate the main dial to set the desired frequency. D Selecting a tuning step • Selecting selectable tuning steps TUNING STEP [DOWNZ]/[YUP] [F-1•Y] [F-2•Z] [F-4•DEF] [EXIT/SET] Main dial 14 preset tuning steps plus 1 programmable tuning step are available. As a default setting, selectable tuning steps can be programmed, depending on the operating mode. Selectable tuning steps can be changed in TS select screen. q Push and hold [▲UP] or [▼DOWN] for 1 sec. to enter the TS select screen to set the selectable tuning steps for each operating mode. w Select the desired operating mode. (p.3-7) e Push [F-1 ▲] or [F-2 ▼] to select the desired tuning step. • 1 Hz, 10 Hz, 100 Hz, 1 kHz, 2.5 kHz, 5 kHz, 6.25 kHz, 9 kHz, 10 kHz, 12.5 kHz, 20 kHz, 25 kHz, 100 kHz, 1 MHz and programmable are selectable. r Rotate the main dial to set the tuning step as the selectable tuning step if desired. • Push and hold [F-4•DEF] for 1 sec. to select the default setting. t Repeat steps e to r to choose the selectable tuning steps. y Repeat steps w to r to set the selectable tuning steps for each operating mode. u Push [EXIT/SET] (or [▲UP]/[▼DOWN]) to exit the TS select screen. Default settings FM : All ON WFM : 20 k, 25 k, 100 k, 1 M, ProgTS AM : 1 k, 5k, 9 k, 10 k, 1 MHz SSB : 1, 10, 1 k, 1 MHz CW : 1, 10, 1 k, 1 MHz FSK : 1, 10, 1 k, 1 MHz P25 : 1 k, 2.5 k, 5 k, 6.25 k, 10 k, 12.5 k, 20 k, 25 k, 100 k, 1 MHz 3-5