Icom IC-R9500 Instruction Manual - Page 113
Memory scan
View all Icom IC-R9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
SCANS 8 ■ Memory scan D Setting [F-4•MEMO] [EXIT/SET] Main dial [BANK] All memory channels (except skip channels) in the selected bank are scanned at up to 40 ch/sec. q Push [EXIT/SET] several times to close a multifunction screen, if necessary. w Push [F-5•SCAN] to select scan setting screen. e Push [F-4•MEMO] once to enter the bank selection. r Rotate the main dial to select the bank limit setting. • Selected bank number or OFF (Bank OFF) appears. t Or rotate [BANK] to select the other bank. y Push [F-4•MEMO], then rotate main dial to select the edge channel. u Push [F-4•MEMO], then rotate main dial to select the other edge channel. i Push [F-4•MEMO], then rotate main dial to select the desired select memory channel group for select memory scan. • '★1' to '★9' and 'ALL' are available. o Push [F-4•MEMO] to set the memory scan. D Memory scan operation [SQUELCH] [EXIT/SET] [MEMO] q Push [EXIT/SET] several times to close a multifunction screen, if necessary. w Set the [SQUELCH] control open or closed. • See page 8-3 for squelch condition. e Push [MEMO] to start the memory scan. • Scan screen appears and memory mode is selected automatically. • " MEMORY SCAN " and decimal points blink during memory scan. r When the scan detects a signal, the scan stops, pauses or ignores it depending on the resume setting and the squelch condition. t To cancel the scan, push [MEMO]. • Pushing [F5•STOP] also cancels the scan. • Pushing [EXIT/SET] closes the scan screen. 2 or more memory channels must be programmed for memory scan to start. 8-11