Icom IC-R9500 Instruction Manual - Page 187
DIP address setting
View all Icom IC-R9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 187 highlights
D IP address setting [F-5•OTHERS] [F-7•SET] 15 UPDATING THE FIRMWARE When updating the firmware from the USB-Memory, setting the IP address is not necessary. IMPORTANT!: A fixed (static) IP address is used for the IC-R9500. When you connect the IC-R9500 to a LAN, ask the network manager about a usable/assignable IP address and the subnet mask in advance. NEVER use an IP address that has already been allocated to another device in the network. If the IP address is duplicated, the network will crash. q Push [EXIT/SET] several times to close a multifunction screen, if necessary. w Push [F-7•SET] to select set mode menu screen. e Push [F-5•OTHERS] to select the others set mode. [F-1•Y] [F-2•Z] [F-3 EXIT/SET] r Push [F-1•Y]/[F-2•Z] several times to select "IP Address." t Push [F-3•Ω ≈] to select the desired segment then rotate main dial to set the desired or specified IP address. • "192.168.0.1" is the default setting. y Push [F-2•Z] to select "Subnet Mask" item. u Rotate main dial to set the desired or specified sub- net mask. • "255.255.255.0" is the default setting. i Push [POWER] to turn the receiver power OFF, then ON to accept the new IP address and subnet mask settings. 15-7