Icom IC-R9500 Instruction Manual - Page 117
Skip scan
View all Icom IC-R9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
SCANS 8 ■ Skip scan You can set the selected memory channel as a skip channel which is skipped during memory scan. Its frequency is also skipped during programmed and auto memory write scans. This setting is useful to speed up the scan speed. D Specifying skip channels q Push [EXIT/SET] several times to close a multifunc- tion screen, if necessary. w Push [F-4•MEMORY] to select memory list screen. e While pushing and holding [F-1•ROLL] or [F-2•SET], rotate the main dial to select the memory channel to be specified as a skip channel. • [M-CH] (or [BANK]) control and direct keypad selection can be used. r Push [F-5•SKIP] to select the skip setting ON. • " SKIP " indicator appears. • Push [F-5•SKIP] again to select the skip setting OFF. t Repeat steps e to r to program another memory channel as a skip channel, if desired. y Push [EXIT/SET] to exit the memory list screen. D Programming skip frequencies (for programming scan) q Start programming scan as described on page 8-7. w When the scan pauses on an undesired signal, push and hold [MW] for 1 sec. • The frequency is memorized into the skip bank as a skip frequency. [MW] D Skip scan setting [F-1•Y] [F-4•DEF] [EXIT/SET] Main dial q Push [F-5•SCAN] to select scan screen. w Push [F-7•SET] to select scan set mode. e Push [F-1•Y] to select "SKIP Function." r Rotate the main dial to select the desired condition. • Push and hold [F-4•DEF] for 1 sec. to select the default setting. t Push [EXIT/SET] to return to scan menu. 8-15