D-Link DXS-3400 User Manual - Page 148

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide Figure 5-50VLAN Mapping Profile (IP, Add Rule) Window The fields that can be configured are described below: Parameter Rule ID Src-IP Address (IP/Mask) Dst-IP Address (IP/Mask) DSCP Source Port Destination Port IP Protocol Action Description Enter the VLAN mapping rule's ID here. If not specified, the rule ID begins from 10 and is incrementedby 10 for every new rule. The range is from 1 to 10000 Enter the source IPv4 address and subnet mask here. Enter the destination IPv4 address and subnet mask here. Enter the DSCP value here. The range is from 0 to 63. Enter the source TCP/UDP port's number here. The range is from 1 to 65535. Enter the destination TCP/UDP port's number here. The range is from 1 to 65535. Enter the Layer 3 IP protocol value here. The range is from 0 to 255. Select the action that will be taken here. Options to choose from are Dot1qTunnel and Translate. • Dot1q-Tunnel - Specifies that the outer-VID will be added for matched packets. • Translate - Specifies that the outer-VID will replace the outer-VID of the matched packets. New Outer VID 802.1P Priority New Inner VID Enter the new outer VLAN's ID here. The range is from 1 to 4094. Select the 802.1p priority value here. The range is from 0 to 7. A lower value has a higher priority. After selecting Dot1q-Tunnel as the action, enter the new inner VLAN's ID here. The range is from 1 to 4094. This option is only available when Dot1q-Tunnel was selected as the action. Click the Back button to return to the previous window. Click the Apply button to accept the changes made. After clicking the Add Rule button next to an IPv6 type profile, the following page will appear. 138