D-Link DXS-3400 User Manual - Page 227

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide Parameter Redistribution Description First, select to enable or disable the RIP redistribution feature here. Second, select the routing protocol (domain) that will be redistributed into RIP. Options to choose from are Connected and Static. The Staticoption means to redistribute IP static routes. The Connectedoption refers to routes that are established automatically by virtue of configuring IP address on an interface. Third, enter the value to be used as the metric for the redistributed route here. The range is from 0 to 16. Fourth, enter the route map's name that is used in the filtering of the routes to be redistributed to the current routing protocol. If not specified, all routes are redistributed. Click the Apply button to accept the changes made. The fields that can be configured in RIP Configurationare described below: Parameter Update Time Invalid Time Flush Time Default Metric Version Distance Description Enter the update interval in seconds at which the update message is sent. The range is from 1 to 65535 seconds. Select the Default option to use the default value here which is 30 seconds. Enter the invalidate timer value in seconds here. The range is from 1 to 65535 seconds. Select the Default option to use the default value here which is 180 seconds. Enter the flush timer value in seconds here. The range is from 1 to 65535 seconds. Select the Default option to use the default value here which is 120 seconds. Enter the default metric value here. The range is from 0 to 16.The default metric is used in redistributing routes from other routing protocols. The routes being redistributed are learned by other protocols and have incompatible metric as RIP. The specifying of the metric allows the metric to be synced. Select the Default option to use the default metric value, which is 0. Select the global RIP version that will be used as the default version for all interfaces here. Options to choose from are v1 (RIPv1) and v2 (RIPv2). Select the Default option to specify that this feature should use the default configuration. By default, RIPv1 and RIPv2 packets are received, but only RIPv1 packets are sent. Enter the administrative distance for RIP here. The range is from 1 to 255. A lower value represents a better route. Select the Default option to use the default administrative distance for RIP, which is 100. Click the Apply button to accept the changes made. RIP Distribute List This window is used to display and configure the RIP distribution list settings. To view the following window, click L3 Features> RIP >RIP Distribute List, as shown below: Figure 6-29RIP Distribute List Window 217